Dakota Digital 3X Series Service Manual download pdf (Page 25)

MAN 650067:G

Exit fuel setup (DONE)

This will allow you to exit the fuel setup and go on to the next setup menu.

• When “Set done” is displayed, press and hold SW1 until you get “ -” “DONE”

• Release the switch to go onto the next menu

PERFORMANCE MENU SETUP

The performance menus can be turned on or off, allowing you to scroll through the

message screens quicker. All of the performance functions are displayed from information that

is already wired to the control box, so disabling will not save any wiring steps.

• Press and hold SW1 while turning the key on.

• Release the switch and then press and release SW1 to get to the “PERF” setup menu.

• Press and hold the switch until “ -” “PERF” is displayed to enter the setup menu, then release

SW1.

• Now you can press and release the switch to toggle from “On”(allowing the performance

readings to be shown), or “OFF”(disabling, hiding the performance readings).

• When the desired option is displayed, press and hold SW1 until you get “ -” “DONE”

• Release the switch to go onto the next menu.

NOTE: In normal operation you have to use SW1 to reset the various performance timers.

A press and hold will zero the current reading, if it can be reset.

NIGHTTIME DIM SETUP

The nighttime dim menu, “NIGHT”, allows you to set the brightness level that the

instrument system will dim down to when the DIM terminal has power applied to it.

If you are using the separately purchased DIM-1 kit from Dakota Digital, this brightness

level doesn’t matter as you have total control of the brightness level with the twist of a knob.

Using the ADJ SND and ADJ – terminals, this setting will be overridden by the DIM-1 knob.

• Press and hold SW1 while turning the key on.

• Release the switch and then press and release SW1 to get to the “NIGHT” setup menu.

• Press and hold the switch until “ -” “NIGHT” is displayed to enter the setup menu, then

release SW1.

• Now you can press and release the switch to gradually dim the displays (you can press and

hold SW1 and the displays will cycle from bright to dim)

• When the desired brightness level is achieved, press and release SW2 to save the

brightness level and go on to the next setup menu.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 35 36

No comments

Dakota Digital 3X Series Service Manual Page 25