Dakota Digital MCL-2011(-R) Service Manual download pdf (Page 8)

MAN# 650369

TRIP SWITCH

The trip switch on the handle bar allows access to all of the mileage, rpm, and performance information. Pressing

and releasing the trip switch toggles through the different displays. Press and holding the switch will reset the current

display. If the switch is pressed while the key is off the clock and odometer can be displayed.

The display sequence is as follows:

CLOCK > 12:00 12 hour clock

ODOMTR > 000000 odometer mileage

TRIP A >

000.0 trip meter mileage A

TRIP B >

000.0 trip meter mileage B

SERVIC > S 0000 miles since last service (if programmed)

KPH > ++++++ metric speed conversion (to mph if metric unit is selected)

* HI SPD > HI 00 high speed recall

* 0-60 T > 60 00.0 0-60mph time (0-100kph)

* QUARTR > 25 00.0 quarter mile time

* QT MPH > 25 00 quarter mile speed

RPM > 0000

RPM

rpm reading in alpha display

* HI RPM > H 0000 high rpm recall

VOLTS > 00.0

displays voltage to gauge

PRESSURE > 00

pressure reading (only shown if sender is connected)

TEMP > 000 F temperature reading, “C” if metric (only show if sender is connected)

* HOURS > HR 0.0 re-settable hour meter

RANGE > R 250.0 or range distance to empty (if turned on)

The 0-60 and ¼ mile timers are zeroed by pressing and holding the switch while that timer is displayed. The timer will not

restart until the speed reaches zero and then you start driving again.

Display functions with a ‘*’ in front of them are only shown with performance readings turned on.

1 2 3 4 5 6 7 8 9

No comments

Dakota Digital MCL-2011(-R) Service Manual Page 8