MAN#650067
DIM PRESET SETUP
Press and hold SW 1 switch while turning the key on. Release the switch. When “DIM”
is displayed, press the switch again and then release it. 88 or 888 will be displayed on the fuel,
oil, volt, and water displays. The system will dim down to the current preset level.
Press and hold SW 1 until the desired night brightness is shown. When the system
reaches its lowest brightness it will start over again at full brightness.
Once the night brightness is correct, press SW 2 to save it.
GEAR DISPLAY SETUP
Press and hold SW 1 switch while turning the key on. Release the switch. When
“GEAR” is displayed, press the switch again and then release it. The current gear display
selection will be shown.
Press and release the switch until the desired setting is shown.
Press and hold the switch until “DONE” is displayed.
TROUBLESHOOTING GUIDE
This is a list of some problems and their solutions which may be encountered when installing your
instrumentation system. If you cannot determine what the problem is or how to solve it, please call our
* A note on vehicle grounding. *
The most common cause of problems with electric gauges is poor ground connections. The
engine block has the highest ground currents of any point in the vehicle. The ignition system, electric
gauge senders, starter, alternator, etc. all use the engine block for a ground point. Since the alternator is
grounded directly to the engine block all ground currents in the entire vehicle must pass through the
engine block while the engine is running. A weak or loose connection can cause all kinds of random
problems that may difficult to track down. The engine block should have heavy ground straps to both the
chassis and the body. The main negative cable from the battery should be connected directly to the
engine block.
Symptom Possible Problem Solution
-----------------------------------------------------------------------------------------------------------------------------------
System does not light up. Control box may not be getting Check if the control box has
power. 12 volts connected to it.
Do not use a battery charger to
power the system.
Control box may not be getting Check if the control box has
a ground. a proper ground connection.
The display system may not be Insert the connector on the
getting power. display system wiring harness
into the slot on the side of the
control box. Be sure the pins
line up properly.
Check the display system wiring
harness for broken or cut wires.
The control box may have Contact Dakota Digital’s service
an internal problem department with a description of
the problem.
(15 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals