Dakota Digital 3X Series Service Manual download pdf (Page 14)

MAN#650067

Press and release the switch until the desired setting is shown. The preset types are

listed in the table below.

Press and hold the switch until “DONE” is displayed.

Sender type

Empty R

Full R

GM 0-30 ohm

GM 30

0 ohms

30 ohms

GM 0-90 ohm

GM 90

0 ohms

90 ohms

GM 40-250 ohm

GM 250

40 ohms

249 ohms

FORD 73-10 ohm

F 73

73 ohms

10 ohms

FORD 20-150 ohm

F 150

20 ohms

150 ohms

VDO 10-180 ohm

V 180

10 ohms

180 ohms

SW/SUN 33-240

SW 33

240 ohms

33 ohms

User settable

CUSTOM

User settable

Custom Fuel setup

You will either need to have the sender out of the tank, or begin with the tank empty and

add fuel during the setup.

When “CUSTOM” is displayed press and release the switch.

The speed display will show the current sender resistance seen by the control box.

The message display will show “SET 00”. Move the float to the empty position and then

press and release the switch.

The message display will show “SET 33”. Release the switch and move the float to 1/3

full and then press and release the switch.

The message display will show “SET 66”. Release the switch and move the float to 2/3

full and then press and release the switch.

The message display will show “SET 99”. Release the switch and move the float to the

full position and then press and release the switch. The new sender is now stored under

the “CUSTOM” sender selection.

The message display will show begin going back through the main menu. When “FUEL”

is displayed, press and release the switch.

When “SENDER” is displayed press and release the switch.

The current sender setting will now be displayed. Press and release the switch until

“CUSTOM” is displayed.

Press and hold the switch until “DONE” is displayed.

TACHOMETER SETUP

The control box can be set to read from 1-15 cylinder ignition signals. It can also be set

to read either 12 volt tach signals or 5 volt tach signals found on some engine computers. The

digital tachometer update rate can be adjusted between slow, mid, and fast. The rpm

warning/shift point can be adjusted from 2200 – 14800. The tachometer will read from 350 –

17,500 rpm. At rpm’s above 9990 the reading will be displayed as rpmx1000 (12,000=12.00).

Press and hold SW 1 switch while turning the key on. Release the switch. When “TACH”

is displayed, press the switch again and then release it. The message display should switch

between “ENGINE”, “UPDATE”, “WARN” and “SIGNAL”.

Engine cylinder setup

When “ENGINE” is displayed press and release the switch.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments

Dakota Digital 3X Series Service Manual Page 14

Comments to this Manuals

Related products and manuals for Motor vehicle electronics Dakota Digital 3X Series