Dakota Digital LAT-NR190 User Manual download pdf

INSTALLATION INSTRUCTIONS

LAT-NR190

LED Tail Lights for 1955 Chevy Car

MAN#650183

Kit Includes:

Installation:

1. Remove the chrome trim pieces and tail light lens.

2. Remove the light bulb

3. Push and twist to remove the plastic bulb socket from the back side

of the housing.

4. Now is a good time to clean the lens and housing. If lenses are in bad shape a new set is

recommended.

5. Remove the nut and flat plastic back plate from the back of the new LED assembly.

6. Make sure that one wire is still going through each hole in the aluminum

spacer. Insert the new LED assembly into the hole where the original

bulb and connector were located. Use caution when feeding the wires

through to avoid damaging the wire insulation.

7. Guide the wires through the plastic back plate and slide the back plate

onto the stud sticking out the back side of the housing. Ensure wires are

not pinched to avoid shorting!

8. Secure the back plate with the supplied #6 lock nut.

9. Make sure the original lens gasket is in place and replace the taillight lens.

Tighten the screws down carefully. Replace the chrome trim pieces.

MAN#650183

1 2

INSTALLATION INSTRUCTIONS LAT-NR190 LED Tail Lights for 1955 Chevy Car MAN#650183 Kit Includes: Installation: 1. Remove the chrome trim pieces and

Page 2

10. Cut off the existing light socket as it will not be used. Do not strip the wires. Trim the wires from LED assembly to appropriate length once m

No comments

Dakota Digital LAT-NR190 User Manual