Dakota Digital LAT-NR101 User Manual download pdf (Page 2)

4. Now is a good time to clean the lens and housing. If lenses are in bad shape a new set is

recommended.

5. Remove the mounting plate from the bottom of the assembly; it is attached with two 3/8” 6-32

machine screws.

6. Pass the wires through the housing where the original bulb and socket where.

7. Feed the wires through the larger hole in the mounting plate and guide it to the bottom of the

housing. The flat side of the mounting plate should be on the outside of the housing and the

side with the slight raised center should go into the tail light housing. This will properly align the

mount in the original housing.

8. Now hold the LED assembly centered over the hole where the original bulb was and align the

mounting plate from the bottom with the slot in the housing. Position the LED assembly so the

screw holes line up.

MAN# 650195

1 2 3 4

No comments

Dakota Digital LAT-NR101 User Manual Page 2