650066
Press and hold the switch until “DONE” is displayed.
Display update setup
When “UPDATE” is displayed press and release the switch.
The update setting will be displayed. (1=slow, 2=mid, 3=fast)
Press and release the switch until the desired setting is displayed.
Press and hold the switch until “DONE” is displayed.
Rpm warning setup
When “WARN” is displayed press and release the switch.
The current warning point will be displayed.
Press and release the switch until the desired setting is displayed.
Press and hold the switch until “DONE” is displayed.
Tach signal setup
When “SIGNAL” is displayed press and release the switch.
The setting will be displayed. (NORMAL or LO VOLT)
Press and release the switch until the desired setting is displayed.
Press and hold the switch until “DONE” is displayed.
WATER TEMP SETUP
Press and hold SW 1 switch while turning the key on. Release the switch. When
“WATER” is displayed, press the switch again and then release it. The message display should
switch between “UNIT”, “WARN” and “TEST”.
METRIC SELECTION
If you are setting the system up for metric displays, press the switch when “UNIT” is
displayed.
Press and release the switch until “KPH C” is displayed.
Press and hold the switch unit “DONE” is displayed.
Temp warning setup
When “WARN” is displayed press and release the switch.
The current warning point will be displayed.
Press and release the switch until the desired setting is displayed.
Press and hold the switch until “DONE” is displayed.
OIL PRESSURE SETUP
Press and hold SW 1 switch while turning the key on. Release the switch. When “OIL” is
displayed, press the switch again and then release it. The message display should switch
between “WARN” and “TEST”.
Pressure warning setup
When “WARN” is displayed press and release the switch.
The current warning point will be displayed.
Press and release the switch until the desired setting is displayed.
Press and hold the switch until “DONE” is displayed.
DIM PRESET SETUP
Press and hold SW 1 switch while turning the key on. Release the switch. When “DIM”
is displayed, press the switch again and then release it. 88 or 888 will be displayed on the fuel,
oil, volt, and water displays. The system will dim down to the current preset level.
(6 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals