Dakota Digital STR6D Installation Manual

- 1 - CRS-2000 & CRS-3000 Cruise Control System Introduction You have purchased o

- 10 - ATTACHING CRUISE CABLE TO THROTTLE (Continued) E. General Motors™ and Chrysler

- 11 - ANCHORING CRUISE CABLE There are three (3) types of connectors used to anch

- 12 - ANCHORING CRUISE CABLE (CONTINUED) 4. Insert the CRUISE CABLE through the bl

- 13 - ANCHORING CRUISE CABLE (CONTINUED) 4. The FLAG NUT may also be used to anch

- 14 - CONTROL SWITCH INSTALLATION If your cruise control switch is the type which c

- 15 - Gray - Vehicle Speed Sensor (VSS) Wire The Gray Vehicle Speed Signal (VSS) wir

- 16 - TROUBLESHOOTING SELF DIAGNOSTIC TESTING PROCEDURE The Cruise Control is equi

- 17 - TROUBLESHOOTING Continued B. Auxiliary Speed Sensor ([SIGNAL GENERATOR or MAG

- 18 - Troubleshooting Guide IMPORTANT: Make sure to always disconnect the negative

- 19 - WARRANTY The Manufacturer warrants to the original retail purchaser of the Dako

- 2 - Additional Notes: Wiring Information: The wire connections that you will n

- 20 - OPERATING INSTRUCTIONS XII. Dakota Digital Cruise Control OPERATING INSTRUCT

- 3 - Please Note: If you are using L.E.D. taillights please wire a relay as shown he

- 4 - Dakota Digital ELECTRIC CRUISE CONTROL UNIVERSAL APPLICATION, INSTALLATION, &a

- 5 - SAFETY PROCEDURES This unit is a microprocessor based Cruise Control. It is d

- 6 - 3. AIRBAG AND ANTI-THEFT RADIO: A. If vehicle is equipped with an Anti-Theft R

- 7 - INSTALLATION 1) CRUISE MODULE MOUNTING NOTE: DO NOT MOUNT THE CRUISE MODULE

- 8 - MEASURING THROTTLE CABLE TRAVEL (Continued) F. Install the end bead of the BEA

- 9 - ATTACHING CRUISE CABLE TO THROTTLE (Continued) B. Pulley Assembly (Dual) Usin