Dakota Digital LAT-NR130 User Manual download pdf (Page 2)

6. Insert the new LED assembly through the hole where the original bulb and connector were.

Use caution when feeding the wires through to avoid damaging the wire insulation.

7. Feed the wires through the large hole on the back plate. The flat side of the back plate should

be toward the outside and the side with the slightly raised center should go in toward the

housing. Guide the back plate onto the back side of the housing.

8. Secure the back plate with the supplied #6 screw and lock washer.

9. Make sure the original lens gasket is in place and replace the tail light lens. Tighten the

screws down carefully.

1 2 3

No comments

Dakota Digital LAT-NR130 User Manual Page 2