Dakota Digital 6000 Series Installation Manual download pdf (Page 7)

Troubleshooting guide continued.

Problem Possible cause Solution

Neutral, low oil, or engine Loose or incorrect connection Check that the appropriate indicator wire

indicator does not work. to indicator wire. has about 12 volts when the indicator

should be off and about 0 volts when the

indicator should be on.

Turn signals do not cancel Output speed signal to stock Check the connections on the solid

automatically. cancel is loose or not white wire coming from the gauge.

connected properly.

Speedometer is not calibrated. Calibrate the speedometer.

Speed sensor is not working. If the speedometer always shows

zero, check speed sensor voltages.

Turn signal cancel module is Test turn signal module according

not working. to the bike’s service manual.

Speed sensor voltage checks. All checks should be made with the sensor connected to the gauge and the key

on. Checks should be done with a volt meter and not a test light.

3-wire sensor: Red wire should have 9-11 volts dc, slightly less than battery voltage.

Black wire should show ground, 0 volts dc at all times.

White wire should vary between 0 and 5 volts dc as the gear teeth pass by the sensor.

2-wire sensor: Measure the voltage between the two sensor wires. With the wheel spinning the voltage should be

about 1-10 volts ac (make sure the meter is set to AC volts and not DC volts for this check).

WARRANTY

All DAKOTA DIGITAL instruments are warranted free of defects in material and workmanship for 2 years

from the date of purchase. In the event of a problem with one of our products within the warranty period, DAKOTA

DIGITAL will replace or repair the instrument at no charge. (The decision to repair or replace is solely that of

DAKOTA DIGITAL. DAKOTA DIGITAL is not responsible for shipping costs of products returned under warranty or

for labor charges for product installation and removal.) This warranty becomes invalid if the product is misused,

altered or installed incorrectly.

For warranty coverage, you must first call to receive an RMA#. Ship the product transportation prepaid via

UPS or insured Parcel Post. A copy of the original invoice or dated bill of sale along with a description of the defect

is also required. Make sure that the RMA number is clearly visible on the outside of the package as well as inside

on the paper work. A note or letter must be included describing the problem.

The above warranties, both expressed and implied, do not cover damages caused by improper installation,

misuse, abuse, fire, unauthorized modifications, floods or acts of God, or reimbursement of customer or shop time.

The extent of the warranty is limited only to the product and does not cover any loss or damage to vehicle,

equipment, or non-DAKOTA DIGITAL products.

SERVICE AND REPAIR

DAKOTA DIGITAL offers complete service and repair of its product line. In addition, technical consultation

is available to help you work through any questions or problems you may be having installing one of our units. You

can contact our technicians at 605-332-6513 or by email at dakot[email protected].

Should you ever need to send the unit back for repairs, please package the product in a good quality box

along with plenty of packing material. Ship the product by UPS or insured Parcel Post. Be sure to include your

RMA#, a complete description of the problem, your full name and address (street address preferred), and a

telephone number where you can be reached during the day. A return authorization number (RMA#) for

products being return for repair is required. Do not send any money. We will bill you for the repair charges.

4510 W. 61ST St. N., Sioux Falls, SD 57107

Phone: (605) 332-6513 FAX: (605) 339-4106

www.dakotadigital.com

[email protected]

1 2 3 4 5 6 7

Comments to this Manuals

No comments

Dakota Digital 6000 Series Installation Manual Page 7

Comments to this Manuals

Related products and manuals for Motorcycle Accessories Dakota Digital 6000 Series