Dakota Digital LAT-NR140 User Manual download pdf

INSTALLATION INSTRUCTIONS

LAT-NR140

LED Tail Lights for ’68-‘69 Nova

MAN#650157

Kit Includes:

Installation:

1. Remove the tail light lens.

2. Remove the light bulb.

3. Remove the original bulb connector from the back side of the housing.

4. Now is a good time to clean the lens and housing. If lenses are in bad shape a new set is

recommended.

5. Insert the supplied rubber grommet into the hole where the original light socket was located.

This will protect the wires from rubbing on the metal edge.

6. Make sure the stock lens gasket is removed from the housing and place the supplied drill

template into the housing and drill three 3/32” holes.

7. Route the wires out through the opening of the rubber grommet. Insert the new LED assembly

and secure it in place with the supplied #4 self-tapping screws. Tighten the screws down

carefully to avoid stripping out the holes. Only two screws are required to secure it properly

but a third is provided in case it is necessary. A machine screw (not supplied) can also be

used with a nut placed on the back of the housing if desired.

8. Place the original lens gasket back into the tail light housing and replace the tail light lens.

Tighten the screws down carefully.

MAN#650157

1 2

INSTALLATION INSTRUCTIONS LAT-NR140 LED Tail Lights for ’68-‘69 Nova MAN#650157 Kit Includes: Installation: 1. Remove the tail l

Page 2

9. Cut off the existing light socket as it will not be used. Do not strip the wires. Trim the wires from LED assembly to appropriate length once mo

No comments

Dakota Digital LAT-NR140 User Manual